Waeco MAGIC WATCH MWE-1000-4FM Instrucciones De Montaje Y De Uso página 46

_MWE-1000-4FM.book Seite 46 Dienstag, 9. August 2005 11:30 11
Using MAGIC WATCH
As you reverse, the sequence of beeps changes according to the zone the
obstacle is in, thus indicating the distance (the "Performing a functional test"
chapter on page 44).
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps and the display.
Caution
Stop the vehicle immediately and investigate the situation (getting
out if necessary), if the following happens while you are reversing:
The device first shows an obstacle while you drive in reverse, and
the beeps speed up as normal (e.g. from slow to medium). Suddenly
the beeping sound slows down, or no obstacle is shown at all.
This means that the original obstacle is in the blind spot of the sensors
(construction-related characteristic), and it is possible to hit it.
8.1 Adjusting the zero point of the sensors
You can move the displayed zero point of the reversing distance sensor if the
sensors are not fitted exactly at the end of the vehicle (for example if a
bicycle rack is fitted on it).
Objects fitted to the vehicle may not be in the detection range of
the sensors.
To do this, move the switch (k 5, page 9) according to the following table.
Switch position
0.0
0.1
0.3
0.5
Note:
Remember that no obstacles can be detected between the sen-
sors and the new zero point, e. g. 0.5 m.
46
Meaning (l, page 9)
The zero point is not adjusted.
The zero point is moved 10 cm to the rear.
The zero point is moved 30 cm to the rear.
The zero point is moved 50 cm to the rear.
magic watch