KNOVA KN M-2504RC Manual Del Usuario página 10

ASSEMBLY
5. Tighten using two 17 mm wrenches for the nut and bolt.
NOTE: Do not overtighten. Doing so will not allow the
wheels to turn.
6. Repeat the steps 4 - 5 for
assembling the other wheel.
Fig. A
Fig. B
5
7
6
SETTING UP THE STAND (FIG. C, D)
1. Lift the stand to its upright position.
2. Raise leg set (1) all the way up. Then, lower the stand
until leg set (1) rests on floor.
3. Release the locking hook (2) from the stop screw (3).
4. Step on the bottom right stand bar (4) for leverage,
grasp right side of stand frame (7) with both hands and
pull stand up to the highest position.
NOTE: You should hear a "click" sound when the stand
locks in place.
1
9
Fig. C
2
1
4
10
9
8
8
2
4
5. Check to be sure the stand lock lever (5) is in the slot of
the cover plate (6). (Fig. D)
3
ASSEMBLING TABLE SAW TO STAND (FIG. E)
1. Lift the saw body (1) and place on the stand (2), aligning
the four mounting holes (3) on the saw base with the four
threaded mounting holes on the top plate of stand.
2. Attach the table saw to the stand with four hex head
bolts (4) and washers (5).
3. Tighten all mounting bolts with a 13 mm wrench.
NOTE: Do not overtighten the four bolts as this may
cause damage to the base of the saw.
6
4. Place the stand on a level surface and adjust the leveling
foot (6) located on the left front stand leg. Adjust until all
legs are contacting the floor and are at a similar angle to
the floor.
3
NOTE: Before using the saw, verify that the table saw is
securely locked in position.
FOLDING THE STAND FOR TRANSPORT OR STORAGE
(FIG. C, D, F)
1. Lift slightly the right side of table saw (8 - Fig. F), raise
the cover plate (6) on the right side of stand, pull the
stand lock lever (5) to the right as the release direction,
7
and then move the saw slowly close to the wheel. (Fig. D)
2. Rotate the hook (2) to the stop screw (3) to secure the
legs of the stand in position. (Fig. C)
3. Rest the right side of the saw onto the floor.
4. Fold the leg set (1) close to the base until the leg
9
clamp (9) holds the right side leg. (Fig. C)
1
2
stand lock lever
release direction
5
6
Fig. D
Fig. E
4
5
3