KNOVA KN M-2504RC Manual Del Usuario página 11

ASSEMBLY
5. Fold the stand slowly downward as shown in Fig. F.
6. Move the saw to the desired location for operation or
store the saw in a dry environment by using the left side
stand handles (10).
8
Fig. F
STORAGE
Rip fence and miter gauge (Fig. G)
Storage for the rip fence (1) and miter gauge (2) are located
on the left side of the saw housing.
1
Fig. G
Extra saw blade
and blade wrenches
(Fig. H)
1. Loosen and remove the knob (1) on the right side of the saw
housing.
2. Place blade wrenches (2), extra blades (not included) onto
the arbor.
2
1
Push stick (Fig. I)
A storage holder for
the push stick (1) is
located on the left
side of the saw
housing.
1
1. Store
the push
stick (1)
by hanging it on the
holders (2) through
the holes (3) of
the push stick (1).
Fig. I
Transporting
10
2
3
Installing the power cord storage clamps (Fig. J)
1. Attach the power cord storage clamp (1) into the hole set
on the rear side of the table saw base with screw (2) and
nut (3).
NOTE: The nut is placed inside the base.
2. Repeat for the other clamp, to be located on the bottom
right on saw base.
Folding
Power cord (Fig. J-1)
Wrap the power cord (1) as shown. Do not wrap the power
cord around the dust port (2).
Fig. H
INSTALLING THE HANDWHEEL HANDLE (FIG. K)
NOTE: UP-DOWN is printed on this handwheel.
1. Thread the handwheel
handle (1) into
the handwheel
hole (2), and
then tighten.
INSTALLING
THE REAR
2
OUTFEED
SUPPORT
(FIG. L, M)
1. Insert the
two rear
outfeed
support
tubes (2) into the rear outfeed support (1). (Fig. L)
NOTE: They must be inserted into the back of the
extension with the dimple end so that the bar will hold
the extension in place.
2. Snap two black plastic stops (3) over the two rear outfeed
support tubes (2). Make sure the locating pin in the black
plastic stops fits into the matching hole in the support
tube. This will "lock" the tube into the support. (Fig. L)
NOTE: The plastic stops (3) must be installed underneath
10
the rear outfeed support tubes (2).
3
1
2
2
1
2
Fig. J
Fig. J-1
Fig. K
1