Installing The Blade - KNOVA KN M-2504RC Manual Del Usuario

ASSEMBLY
dimple end
3. Insert the rear outfeed
support tubes (2) into
the two holes in the rear
of the saw table, and into the
support tube brackets under the table. Position the rear
outfeed support so that the instruction labels are facing
up. (Fig. M)
4. Tighten one rear outfeed support stop screw (4) on the
end of the left rear outfeed support tubes (2). Verify that
the screw is fully inserted into
the corresponding hole in
the support tube. (Fig. M)
2
INSTALLING
THE BLADE
(FIG. N, O, P)
WARNING
To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
NOTE: The saw blade is packed in the blade storage
located on the right side of base.
1. Remove the table insert (1) by inserting your finger into
the opening (2) and pulling up. Raise the blade to the
maximum height position by turning the
blade elevation/tilting handwheel
clockwise. (Fig. N)
Fig. N
2. Remove the
arbor nut (3)
and outer blade
flange (4). (Fig. O)
6
4
5
Fig. O
1
2
3
2
1
3
3. Place the blade (7) onto the arbor (5) with the blade teeth
Fig. L
pointing forward to the front of the saw. (Fig. P)
NOTE: Leave the plastic strip around the saw blade at
this time. Remove before using the saw for the first time.
4. Make sure the blade fits flush against the inner flange (6).
(Fig. O)
5. Clean the outer blade flange (4) and install it onto the
arbor (5) and against the blade (7). (Fig. P)
6. Thread the arbor nut (3) onto the arbor, making sure the
flat side of the nut is against the blade, then hand-tighten.
7. To tighten the arbor nut (3), place the open-end
wrench (8) on the flats of the saw arbor to keep the
arbor from turning. (Fig. P)
8. Place the box-end wrench (9) on the arbor nut (3) and
turn clockwise (to the rear of the saw table). (Fig. P)
9. Lower the blade to its lowest position and place table
insert (1) into position. (Fig. N)
4
Fig. M
WARNING
the workpiece, be sure to INSTALL THE BLADE
WITH THE TEETH POINTING TOWARD THE FRONT
OF TABLE in the direction of the rotation arrow on
the blade guard.
REMOVING THE BLADE (FIG. N, P)
WARNING
2
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
1. Remove the table insert (1) by inserting your finger into
the opening (2) and pulling up. Raise the blade to the
maximum height position by turning the blade
elevation/tilting handwheel clockwise. (Fig. N)
2. To loosen the arbor nut (3), place the open-end wrench (8)
on the flats of the saw arbor to keep the arbor from
turning. (Fig. P)
3. Place the box-end wrench (9) on the arbor nut (3) and turn
counterclockwise. (Fig. P)
4. Remove the arbor nut (3), outer blade flange (4) and
blade (7). Clean but do not remove the inner blade flange
before reassembling the blade. (Fig. P)
11
8
3
9
To avoid possible injury and damage to
To avoid injury from an accidental start,
7
4
Fig. P
5