Bell HP7 Manual De Instrucciones página 12

7
8
10
ADJUSTABLE TEAR-OFF POSTS
Using the Bell Hex Wrench, a coin or a flat head screwdriver, turn the
adjustable tear-off posts so the widest part of the posts are toward the center
of the face shield. See Illustration 7. Stack the tear-offs to your preference.
Rotate the adjustable tear-off posts until the tear-offs are tight, as shown in
Illustration 7.
Some models come with tear-off posts pre-installed, while others may require
installation (instructions provided). Do not use thread lock under any
circumstances especially if using aftermarket tear-off posts as the chemicals
can damage the shield.
VISOR PEAK
Open face models come with the visor peak attached and some full face
models can be used with a visor peak that attaches to the helmet using the
shield pivot screws and SV friction screws. Check the visor peak for even
alignment. Use the Hex Wrench to loosen and adjust the peak as needed.
DO NOT OVERTIGHTEN
the screws. Illustration 8.
It is the wearer's responsibility to determine if this helmet affords adequate
vision and hearing. We recommend the use of earplugs to reduce the
likelihood of permanent damage to your hearing.