Bell HP7 Manual De Instrucciones página 9

ADJUSTMENT
Adjustment of the eccentric button on the lower left side of the eye opening is possible to fine tune the closing
action of the shield. Using a Hex Wrench (included in the box for all full face helmets), loosen the set screw and
rotate the button so that the shield latches easily but securely over the button when is it pulled down by the top
center edge with one hand. When adjusted to your preference, tighten the set screw.
The shield opens and closes using a using an SV friction tension system that controls how much pressure is
needed to open or close the shield.
To adjust the tension on the shield, use the Hex Wrench, 3/32" or 2.4 mm hex wrench to tighten or loosen the
set screw to the desired level of tension.
7