Progress PDI9075E Manual De Instrucciones página 29

Regenerable carbon filter
The carbon filter must be regenerated every
two months (or when the filter saturation
indicator - if present - indicates the need for
it) and in accordance with the procedure as
shown here below:
1. Disconnect the electrical appliance from
the mains.
2. Clean the filter's surface with a damp
cloth to remove grease deposits.
3. Put the filter in an oven at 200 degrees
for 45 minutes.
4. Turn off the oven and wait for an hour
before taking out the filter.
Attention! Make sure the filter has cooled
down before touching it.
Controls
The hood is fitted with a control panel with aspiration speed selection control and a light
switch to control cooking area lights.
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended
that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave
in operation during cooking and for another 15 minutes approximately after terminating
cooking.
The control switches are located on the unit's front panel:
T7
T1 Button Speed (power) of suction 1
T2 Button Speed (power) of suction 2
T3 Button Speed (power) of suction 3
T4 Button ON/OFF Speed (power) of
suction 4
Note: The Speed (power) of suction 4
remains in function for 5 minutes, then
the it returns to the previous setting.
All manuals and user guides at all-guides.com
T6 T1
Type SUPCHARC-E
T2 T3
T5 Button for filter saturation control
T6 Button OFF speed
Button for control panel activation­
deactivation
T7 Button ON/OFF lights
Button for activation/deactivation of
charcoal filter saturation control
progress 29
T4 T5