Berner 175188 Manual Original página 9

Cargador baterias
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
TECHNICAL DATA
Voltage range ..................................
Quick charge current .......................
Maintaining charge current ..............
Battery charging time with 1.5 Ah ....
Battery charging time with 3.0 Ah ....
Weight according EPTA-Procedure
01/2003............................................
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
may result in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Do not dispose of used battery packs in the household
refuse or by burning them. Your power tool distributor will
normally retrieve old batteries to protect our environment.
Only the following battery packs can be charged with this
charger:
voltage
battery
(of storage battery)
14,4 V
BBP14,4V -1,5Ah
14,4 V
BBP14,4V -3Ah
14,4 V
BBP14,4V -4Ah
18 V
BBP18V -2Ah
18 V
BBP18V -3Ah
18 V
BBP18V -4Ah
18 V
BBP18V -5Ah
Do not try to charge non-rechargeable batteries with this
charger.
Do not store the battery pack together with metal objects
(short circuit risk).
No metal parts must be allowed to enter the battery section
of the charger (short circuit risk).
Never break open battery packs or chargers and store only
in dry rooms. Keep dry at all times.
Never charge a damaged battery pack. Replace by a new
one.
Before use check machine, cable, and plug for any
damages or material fatigue. Repairs should only be carried
out by authorised Service Agents.
This appliance is not intended to
be used or cleaned by persons
with reduced physical, sensory or
mental capabilities, or lack of
experience or knowledge, unless
they have been given instructions
concerning the safe use of the
appliance by a person legally
responsible for their safety. They
should be supervised whilst using
the appliance. Children shall not
use, clean or play with this
appliance, which when not in use
should be secured out of their
reach.
ENGLISH
395 489 - Berner-BBC14-4-18V.indd Abs1:8
395 489 - Berner-BBC14-4-18V.indd Abs1:8
BBC 14,4-18V
..................14-18 V
......................3,0 A
.....................500 mA
.......................30 min
.......................60 min
.....................620 g
rating
No. of
battery
cells
≤ 1,5 Ah
4
≤ 3,0 Ah
2x4
≤ 4,0 Ah
2x4
≤ 2,0 Ah
5
≤ 3,0 Ah
2x5
≤ 4,0 Ah
2x5
≤ 5,0 Ah
2x5
SPECIFIED CONDITIONS OF USE
The quick charger can charge Berner Li-ion batteries from
14 V - 18 V.
Do not use this product in any other way as stated for
normal use.
MAINS CONNECTION
Connect only to single-phase AC current and only to the
system voltage indicated on the rating plate. It is also
possible to connect to sockets without an earthing contact
as the design conforms to safety class II.
Li-Ion BATTERIES
The rechargeable batteries are partially charged. The LED
on the battery indicates the state of charge.
If it is not used for long periods, the rechargeable battery will
switch to the non-operative state.
When fully discharged the rechargeable battery switches off
automatically (depth discharge not possible).
Under extreme circumstances, the internal temperatur of the
battery could become to high. If this happens, the battery
will shut down.
Place the battery on the charger to charge and reset it.
The state of charge can be read by pressing the button on
the rechargeable battery. The battery can be left in the
electric tool while the reading is taken but it must be
switched off at least one minute beforehand (otherwise the
display will be inaccurate). The number of LEDs illuminated
indicates the state of charge. A fl ashing LED indicates a
max. power reserve of 10%.
As a general principle, if the electric tool should fail to work
after inserting the rechargeable battery, then the battery
should be plugged into the charger. The displays on the
battery and charger will then provide information about the
condition of the battery.
In low temperatures work may continue at reduced output.
CHARACTERISTICS
After inserting the battery into the reception of the charger
the battery will automatically be charged (red control lamp is
illuminated continuously)
When a hot or cold battery pack is inserted into the charger
(fl ashing red lamp), charging will begin automatically once
the battery reaches the correct charging temperature
(0°C...65°C). The max. charging current is fl owing when the
temperature of the Li-Ion-battery is between 0°C and 65°C.
The battery's charging time is between 1 min and 30 min (at
1,5 Ah), depending on the state of discharge.
Once the battery is fully charged, the LED on the charger
changes from red to green.
It is not necessary to remove the battery after charging. The
battery can be stored permanently in the charger without the
danger of being overcharged.
If both LEDs fl ash alternately then the rechargeable battery
is either not fully pushed in or there is a fault with the battery
or charger. Take the charger and battery out of use
immediately for safety reasons and have them inspected by
a Berner customer service centre.
MAINTENANCE
If the supply cord of this appliance is damaged, it must only
be replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required
Use only Berner accessories and Berner spare parts.
Should components need to be replaced which have not
been described, please contact one of our Berner service
agents (see our list of guarantee/service addresses).
8
05.06.2015 13:54:37
05.06.2015 13:54:37

Publicidad

Tabla de contenido
loading

Tabla de contenido