Roland Lucina AX-09 Guía Rápida página 11

Using the Touch Controller and Modulation Bar
If you place your finger on the touch controller and move
1
it to left and right, the pitch will change.
2
By pressing the modulation bar you can apply vibrato.
For the special tones "VIOLIN" and "TROMBONE, " pressing the modulation bar will
vary the dynamics (expression).
☞
For details, refer to p. 11 in the "Owner's Manual."
Using the D Beam
1
Press a button to select the D Beam effect.
D Beam
Explanation
PITCH Modifies the pitch of the sounds you play.
FILTER Modifies the tonal character of the sound you play.
Allows you to assign a desired effect. With the factory settings, an effect
ASSIGNABLE
appropriate for each tone will be applied.
While you perform, position your hand above the
2
D Beam sensor and move it slowly up and down.
☞
For details, refer to p. 12 in the "Owner's Manual."
When you press a button
so it's lit, the effect listed
in the table below will be
applied.
If you press the lit button
once again, the D Beam
will turn off.
9