Technical Specifications - BMR The Flex Arms Manual De Usuario

T
ECHNICAL SPECIFICATIONS
Caring for your controller
Your controller should not be allowed to get wet or be left in excessive sunlight. It may
be cleaned regularly using a soft cloth, lightly dampened in soapy water. Do not allow
the interior of your controller to become wet. Do not use detergents, alcohol, spray
aerosols or strong solvents on your controller.
Access to the interior of the controller is not required for maintenance purposes.
If your product is damaged, you should not use it but should return it to your distributor
for replacement or repair. Repairs, service and modifications may not be carried out by
anyone other than qualified service personnel authorized by BMR.
: Under no circumstance should anything other than the correct type of batteries
IMPORTANT
(rechargeable batteries 3.6V NiMH) be used with your controller. These can be purchased
from www.theflexbelt.com or by calling Customer Care.
Disposing of the GelPads and batteries
Used GelPads and batteries must never be disposed of in a fire but in accordance with
national or state laws governing the disposal of such items.
: The signal gradually increases to a peak intensity level at the start of the contraction
NOTES
phase (i.e. ramp up) and gradually decreases to nothing at the start of the relaxation phase
(i.e. ramp down). When the (i.e. ramp down). When the symbol is flashing, the stimulus is significantly reduced. symbol is flashing, the stimulus is significantly reduced.
Product Type: 397
Intended use: Muscle stimulator
Classification: Internally powered equipment, Class II charger, Type BF applied parts.
14
Waveform: Symmetrical bi-phasic square waveform when measured into a resistive
load.
Accessories:
You can purchase accessories at www.theflexbelt.com. Under no circumstances should
anything other than by BMR accessories be used with your charger or
THE FLEX ARMS
controller (Type 390). Any others may not be compatible with your product and could
degrade the minimum safety levels.
GelPads: • 4 GelPads (Type 718)
THE FLEX ARMS
Garment (X:70)
THE FLEX BELT
GelPads: • 1 large GelPad (Type 732)
THE FLEX BELT
• 2 small GelPads (Type 733)
Belt Extension
G (E:30)
THE FLEX MINI ARMENT
GelPads: • 4 large GelPads (Type 716)
THE FLEX MINI
Battery Pack (3.6V, NiMH)
Battery Charger: 2504-0322
Charger complies to EN 60950, Input: nominal voltage 100-240V, frequency 50-60Hz,
current 125mA. Do not use any other chargers or any other power supplies.
Environmental Specifications:
Operating Range: Temperature: 32 - 95°F
Humidity: 20 - 65 % RH
Transport & Temperature: 32 - 131°F
Storage Range: Humidity: 10 - 90 % RH
Attention:
This product can deliver currents in excess of 2mA/cm if used with incorrect electrodes.
2