Connecting The Iuxs - Sartorius IUXS4-Standard Serie Instrucciones De Instalación

Connecting the IUXS... or IFXS...
Connecting Cable: IUXS.. or IFXS.. to Indicator
V + (Supply voltage +)
V – (Supply voltage –)
Signal + (Output signal +)
Signal – (Output signal –)
Sense + (Shield +)
Sense – (Shield –)
Ground (Shield)
8
Transporting the IFXS4...
(Option T7)
§ Remove the drive-on ramp from
the front of the scale.
§ Make sure there is no load on the
scale.
$ Make sure to observe the safety
instructions.
Remove the threaded caps from the
four threaded fasteners and save
them in a safe place.
$ Lubricate the threaded fasteners
regularly, so that the caps can
be removed and the hand cranks
attached at any time without
difficulty.
Attach the two hand cranks to the
two threaded fasteners at the front
of the scale.
Turn the cranks clockwise to lower
the transport rollers.
$ Repeat this procedure for the two
rear rollers.
Important:
Make sure there is no load on the
platform before you move it.
The scale can now be pushed
into the desired position
(rate of speed: <1m/s).
Please observe the safety
instructions.
No.: EX
1
3
5
6
2
4
Cable: type A or
(white) or
(brown) or
(green) or
(yellow) or
(pink) or
(gray) or
§ If available, fasten the towing bar
(optional) as shown.
$ The scale can now be pulled
into the desired position (rate of
speed: <1 m/s).
Please observe the safety
instructions.
$ This procedure is useful, for
example, for cleaning the surface
beneath the scale at the place of
installation.
§ Return the weighing platform
to the place of installation and
retract the rollers.
§ Remove the hand crank.
§ Replace the four threaded caps.
§ Fasten the drive-on ramp to the
front of the scale.
$ Make sure to observe the safety
instructions.
Cable: type B
blue
black/brown
white
red/pink
green
gray