mothercare westbury Manual Del Usuario página 3

care of your product
Periodically check all fittings to ensure that none have come loose.
The cot can be cleaned by wiping with a damp cloth and drying with a soft dry cloth.
Never clean with abrasive, ammonia based, bleach based, or spirit type cleaners.
Take care when handling or moving the cot. Careless handling can damage wooden
furniture.
safety notes
The lowest base position is the safest and should always be used as soon as the
baby is old enough to sit up.
Never leave anything inside the cot that could provide a foothold or present a risk
of suffocation or strangulation.
If you leave the child unattended in the cot, always make sure that the drop side is
in the highest position.
The thickness of the mattress chosen must not reduce the internal depth (from
mattress surface to the top of the side) to less than 500mm with the base in the
lowest position or 200mm with the base in the highest position. The leg of the cot
has a mark indicating this height.
All assembly fittings should always be tightened properly . Care should be taken
that no screws are loose, because the child could trap parts of the body or clothing,
(e.g. Strings, necklaces, ribbons for babies' dummies), which would pose a risk of
strangulation.
The mattress used with this cot should be no more than 30mm shorter or narrower
than the internal length or width of the cot.
Strong heat sources, e.g. open, electric or gas fires in the vicinity of the cot may be
dangerous if placed near the cot.
Español:
Guía del usuario para la cuna camita Westbury.
Contiene información importante, lea aténtamente
y retenga para referencia futura.
Por favor, recuerde que todas las ilustraciones a las que se hace referencia en
esta guía se encuentran en la sección en inglés al principio de la guía.
Notas importantes
Esta cuna camita cumple con la Norma de
Seguridad BS EN 716-1: 1996 para cunas. Por
favor, tómese unos minutos en leer esta guía
de usuario. Desembale cuidadosamente la
5
All manuals and user guides at all-guides.com
cuna sobre una superficie plana y blanda, tal
como un suelo enmoquetado. Familiarícese
con las piezas, comparándolas con el
catálogo de piezas que sigue. No tire el
embalaje hasta que esté seguro de que tiene
assembly
fig 2
fig 3
1
2
3
Screw the upper dropside pins
into the upper holes of the
dropside legs, using a slot head
screwdriver. (The dropside legs
are distinguishable by the upper
hole being lower than on the
other leg and the metal insert
being smaller).
Screw the lower dropside pins
into the lower hole on the same
side, using a small cross head
screwdriver.
Your cot has 3 mattress positions.
Decide which mattress base
position you require now. The
lowest base position is the safest
and should always be used as
soon as the baby is old enough
to sit up.
Using the 60mm bolts and Allen
key, screw through the cot end
and into the mattress base rails,
inserting one barrel nut into each
pre-drilled hole of the mattress
base rail, for the bolt to secure
into. A slot head screwdriver may
need to be used to align the
barrel nut with the bolt.
To ease assembly do not tighten
the fittings at this stage.
Place the Mattress base between
the rails.
2