Personnel Qualifi Cation; General Safety Instructions - Bosch Rexroth LU 2 Instrucciones De Montaje

• Using the product for lubrication of more than 1 belt section BS 2/... or 1 conveyor
unit SE 2/... .
• Using the product with non-specifi ed lubricants.
• Using the product with non-specifi ed accessories.
• Using the product with lubrication lines of differing lengths.
• Using the product with 2 different lubrication pins.
• Using the product without ensuring that it is in the correct position.
• Private use.
2.4 Personnel qualifi cation
The activities described in this document require a basic knowledge of mechanical,
electrical and pneumatic systems, as well as familiarity with the corresponding
technical terms. Additional knowledge of the use of lifting gear and corresponding
slings is required for transporting and handling the product. To ensure safe use,
these activities should only be performed by a specialist or a person under the
direction and supervision of a specialist.
"Specialist" refers to someone who can recognize possible hazards and take
the appropriate safety measures given his/her technical training, knowledge and
experience, and knowledge of relevant regulations. A specialist must follow with the
relevant rules specifi c to his/her occupation and have the necessary expertise.
Bosch Rexroth offers measures to support training in specifi c areas. You can fi nd an
overview of the training content online at: http://www.boschrexroth.de/didactic

2.5 General safety instructions

• Observe applicable accident prevention and environmental protection regulations.
• Observe the safety rules and regulations of the country in which the product is
being used.
• Only use Rexroth products that are in proper working order.
• Heed all the notices on the product.
• Persons who assemble, operate, disassemble or maintain Rexroth products should
not be under the infl uence of alcohol, drugs or medication that may affect their
ability to respond.
• Use only original accessories and spare parts from Rexroth in order to prevent
hazards to people due to unsuitable spare parts.
• Observe the technical data and ambient conditions specifi ed in the product
documentation.
• Only start up the product if it has been determined that the end product (e.g., a
machine or system) into which the Rexroth products have been installed complies
with national provisions, safety regulations and application standards.
Safety instructions
3 842 358 814/2018-12, MIT: LU 2, Bosch Rexroth AG
9/54