Finishing The Installation - minkaAire Mojo II Manual De Instrucciones Certificado De Garantia

5

FINISHING THE INSTALLATION

Step 1. Remove one of the four screws on the mounting bracket and
loosen, but do not remove, the other three screws.
Step 2. Remove the motor assembly from the J hook.
Step 3. Lift and place the key holes on the mounting plate over the three
screws previously loosened on the mounting bracket and turn the
mounting plate until it locks in place and no longer turns. (FIG. 5)
Step 4. Secure by tightening the three screws previously loosened and the
screw previously removed.
Step 5. Align the four large screwheads pre-locked on the fan housing to
the key holes of the mounting bracket.
Step 6. Turn the fan housing at the right side and twist the screwheads to
the end of the slotted holes until they lock in place and no longer turn.
WARNING: Ensure you complete this step correctly and follow all steps.
Failure to correctly follow this step might cause the fan to fall.
MOUNTING
BRACKET
KEY
HOLES
FAN
MOTOR
ASSEMBIY
Fig. 5 SCREW
MOUNTING
SLOTTED HOLE
BRACKET
KEY
HOLES
SCREWHEAD
FAN HOUSING
Fig. 6