Publicidad
Idiomas disponibles
Idiomas disponibles
3
BASE (G)
ANGLE
BRACKET (K)
1- -5/8" PAN HEAD SCREW (Q)
(3 used in this step)
- Fasten the RIGHT END (A) to the TOP (C), BOTTOM (D) and SHELF (I). Tighten the TWIST-LOCK
FASTENERS in the RIGHT END, BOTTOM, and SHELF.
NOTE:
Be sure the finished edge of the RIGHT END is facing up. Follow the diagram.
- Fasten the TOP MOLDING (H) to the TOP (C). Use three 1- -5/8" PAN HEAD SCREWS (Q) through the
MOLDING and into the pre- -drilled holes in the TOP.
NOTE:
Start each SCREW a few turns before tightening any of them. Do not overtighten.
- Fasten five ANGLE BRACKETS (K) to the RIGHT END (A), LEFT END (B), and BOTTOM (D) as shown.
Use a 9/16" LARGE HEAD SCREW (O) through each BRACKET and into the pre- -drilled holes in the ENDS
and BOTTOM.
NOTE:
Be sure to position the BRACKETS as shown. Be sure the edges of the BRACKETS are even
with the edges of the ENDS and BOTTOM. Follow the enlarged diagrams closely.
- Fasten the BASE (G) to the RIGHT END (A), LEFT END (B) and BOTTOM (D). Use five 9/16" LARGE HEAD
SCREWS (O) through the ANGLE BRACKETS and into the pre- -drilled holes in the BASE.
All manuals and user guides at all-guides.com
SHELF (I)
BOTTOM (D)
ANGLE
BRACKET (K)
www.sauder.com/services
TOP
MOLDING (H)
LEFT
END (B)
RIGHT
END (A)
9/16" LARGE HEAD SCREW (O)
(10 used in this step)
Finished
edge
TOP (C)
R
101785
Publicidad
