Publicidad
Idiomas disponibles
Idiomas disponibles
4
CAUTION: THIS SAUDER UNIT HAS BEEN
DESIGNED FOR THE WEIGHTS SHOWN IN
THIS STEP. EXCEEDING THESE
RECOMMENDED WEIGHTS COULD RESULT IN
EXCESSIVE "SAGGING" OF THE PART.
EXTREME OVERLOADING COULD CAUSE
FAILURE OF THE PART AND POSSIBLE INJURY.
- Carefully turn your unit over onto its front edges as shown in the left diagram. Unfold the BACK (F) and lay it over your
unit with the unfinished surface facing up.
NAILING ON THE BACK:
1st:
Be sure there is an equal amount of margin along all four edges of the BACK (F). If needed, push on opposite
corners of your unit to make sure it is "square".
2nd: Tap a NAIL (P) into the row of holes along the top edge of the BACK.
3rd: Then, tap a NAIL into the row of holes along the bottom edge of the BACK.
NOTE:
If a NAIL is not correctly tapped into the unit, use a putty knife or butter knife under the BACK
to pry it away from the unit. Pry close to the NAIL and it will pop the BACK off the head of the
NAIL. Then use the claw of your hammer to pull the NAIL from the part. When reattaching the
BACK, use the NAIL to make a new hole next to the old hole.
- Continue fastening the BACK (F) to your unit using the NAILS (P).
NOTE:
Be sure to tap NAILS into the holes that line up over the SHELF.
- Now, carefully stand your unit upright as shown in the right diagram.
- Slip a RUBBER SLEEVE (L) over each of the METAL PINS (M). Insert the METAL PINS into the hole locations of
your choice in the ENDS. Set the ADJUSTABLE SHELF (E) onto the METAL PINS.
- Insert HOLE PLUGS (R) into the large holes in the TOP MOLDING (H).
- Please read the back page of the instruction booklet for important safety information.
This completes assembly. Use your favorite type of furniture polish on all finished surfaces to enhance the beauty of the finish.
Do not spray the polish directly onto the furniture. Spray the polish onto a cloth, then use the cloth to wipe the surface.
101785
All manuals and user guides at all-guides.com
STOP
STOP
Do NOT stand the unit
upright without the
BACK fastened. The
unit may collapse.
BACK (F)
Unfinished
surface
LEFT
END (B)
www.sauder.com/services
ADJUSTABLE
SHELF (E)
NAIL (P)
(45 used in this step)
No load
35 lbs.
35 lbs.
40 lbs.
35 lbs.
35 lbs.
Publicidad
