Publicidad
Idiomas disponibles
Idiomas disponibles
10
EXTENSION
RAIL (RR)
SMALL
EXTENSION
BLOCK (G2)
EXTENSION
RAIL (RR)
- Carefully stand your unit upright.
- Separate the EXTENSION SLIDES (SS) from the EXTENSION RAILS (RR). To do this, fully extend the
EXTENSION SLIDE and push down on the black release lever on the SLIDE. Now, pull the SLIDE from the RAIL so
you have two separate parts. Be prepared, the parts are greasy.
- Be sure the inner cartridge of each EXTENSION RAIL (PP) (including the ball bearings) is fully extended as shown.
Fasten two EXTENSION RAILS to the EXTENSION BLOCKS on each END as shown using two 5/16" FLAT
HEAD SCREWS (TT) through each EXTENSION RAIL and into the small holes in the EXTENSION BLOCKS.
Refer to the following note for further instructions.
NOTE:
For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram to
the right. Then slide the inner cartridge of the EXTENSION RAIL in to find the other hole that
lines up with the hole in the EXTENSION BLOCK. Turn a SCREW into this hole.
NOTE:
There must be a CABINET ACTUATOR (W) above each RAIL on the RIGHT END (A3). Be sure
to check the location of the CABINET ACTUATORS before fastening the EXTENSION RAILS
to the EXTENSION BLOCKS.
101702
EXTENSION SLIDE (SS)
LEFT
END (B3)
Fasten the two
remaining EXTENSION
RAILS (P) to the
EXTENSION BLOCKS
on the RIGHT END (A3).
www.sauder.com/services
EXTENSION RAIL (RR)
Push the black lever in and pull the SLIDE from the RAIL.
RIGHT
END (A3)
GOLD 5/16" FLAT HEAD SCREW (TT)
Use this hole.
(8 used in this step)
Publicidad
