Publicidad
Idiomas disponibles
Idiomas disponibles
3
1- -7/8" PAN HEAD SCREW (GG)
SMALL EXTENSION
BLOCK (G2)
Surface with
five holes.
ANGLE
BRACKET (DD)
- Fasten one SMALL EXTENSION BLOCK (G2) to the RIGHT END (A3) as shown. Use three 1- -7/8" PAN HEAD
SCREWS (GG) through the large holes in the SMALL EXTENSION BLOCK and into the pre- -drilled holes in the RIGHT END.
NOTE:
DO NOT OVERTIGHTEN THE SCREWS. Be sure the surface with five holes on the SMALL EXTENSION
BLOCK is facing up. The middle hole is not centered. Use your tape measure. This hole must be
located toward the bottom edge. Follow the diagram closely.
- Fasten two SMALL EXTENSION BLOCKS (G2) to the LEFT END (B3) as shown. Use three 1- -7/8" PAN HEAD
SCREWS (GG) through the large holes in the SMALL EXTENSION BLOCKS and into the pre- -drilled holes in the LEFT END.
NOTE:
DO NOT OVERTIGHTEN THE SCREWS. Be sure the surfaces with five holes on the SMALL EXTENSION
BLOCKS are facing up. The middle holes are not centered. Use your tape measure. These holes must
be located toward the bottom edge. Follow the diagram closely.
- Fasten two ANGLE BRACKETS (DD) to the RIGHT END (A3) and LEFT END (B3) as shown. Use a 9/16" LARGE HEAD
SCREW (KK) through each BRACKET and into the pre- -drilled holes in the ENDS.
NOTE:
Be sure to position the BRACKETS as shown. Be sure the edges of the BRACKETS are even with the
edges of the ENDS. Follow the enlarged diagrams.
(9 used in this step)
LEFT
END (B3)
www.sauder.com/services
These holes are not
centered. They must
be located toward the
bottom edge.
RIGHT
END (A3)
Bottom
edge
ANGLE
BRACKET (DD)
9/16" LARGE HEAD SCREW (KK)
(4 used in this step)
101702
Publicidad
