Sauder Camden County 101702 Manual Del Usuario página 9

5
Flat
edge
BASE (N)
9/16" LARGE HEAD SCREW (KK)
(4 used in this step)
- Fasten the RIGHT END (A3) to the TOP (C), then to the BOTTOM (D) as shown. You will need to slide the END
MOLDING (O2) on the RIGHT END down as you insert the TWIST-LOCK
Tighten the TWIST-LOCK
NOTE: You will need to slide the END MOLDING (O2) down a little to insert the TWIST-LOCK
FASTENERS into the TOP. The END MOLDING should be against the TOP MOLDING (M) after
the END is fastened.
- Fasten the BASE (N) to the RIGHT END (A3) and LEFT END (B3) as shown. Use a 9/16" LARGE HEAD
SCREW (KK) through each ANGLE BRACKET and into the pre- -drilled holes in the BASE.
NOTE: Be sure the flat edge of the BASE is facing as shown. Follow the diagram.
LEFT
END (B3)
BOTTOM (D)
R
FASTENERS in the RIGHT END and BOTTOM.
www.sauder.com/services
TOP
MOLDING (M)
TOP (C)
RIGHT
END (A3)
R
FASTENERS into the holes in the TOP.
END
MOLDING (O2)
R
101702