Bartscher M 10110g Manual De Instrucciones página 66

During acceptance of the gas device a test cooking cycle should be conducted, in order
to ensure the device is functioning without defects or other problems.
Set the temperature dial to 150 ° C, and the time di al to 10 min.
Inspect the following thoroughly:
→ The lighting inside the compartment must come on.
→ The device must turn off when the door is open, and turn on when closed.
→ The thermostat for controlling temperature in the device is activated when the
desired temperature is reached. The heating element(s) are temporarily turned
off. The thermostat comes on when the LED 2 control light on the control panel
goes off temporarily.
→ The ventilation motor must automatically change the rotation direction.
The rotation direction should automatically change every 2 minutes, and
the motor should disengage between direction changes for 20 seconds.
→ Heating elements are temporarily shut off during the motor's 20-second
interruption. This is indicated by the LED 2 control light on the control panel
shutting off temporarily.
→ For devices with 7 or 10 sliding elements: both airflows in the compartment
flow in the same direction.
→ At the end of a cooking / baking cycle the device will emit an audio signal for
approx. 15 seconds.
→ If the device is equipped with a steam system, after turning the appropriate dial
check for water leaks from the hose in the direction of the circulation inside the
compartment.
- 62 -