Installation Place; Preparing For Installation - Bartscher M 10110g Manual De Instrucciones

5.1.2 Installation place

•
The device must be installed in closed and well ventilated rooms (not outdoor).
•
Check the dimensions and the exact position of connections for electricity, water and
extractor connections before installation of the combi steamer.
•
We recommend to install the device under an extractor or to ensure the discharge
outside the hot vapours and odours which emerge from the cooking space.
•
The devicemust be installed on a flat surface in order to prevent it from slipping or
tipping.
•
The installation surface of the combi steamer must be suitable for the weight of the
device at maximum load.
•
Place the device unit on a firm, dry, water-resistant and heat-resistant surface.
The installation surface must be well accessible and big enough to be able to
operate freely with the device and to ensure good air circulation.
•
Install the device in such manner that the rear part is easily accessible in order to
allow the electricity and water connections and maintenance.
•
Never place the device directly against walls, kitchen furniture or other flammable
objects. Proceed according to relevant fire safety regulations.
•
Keep a minimum of 100 mm between the device and walls/other objects on the left
and right sides and at the rear, and 150 mm from the top.
•
The device is not designed to be built-in!

5.1.3 Preparing for Installation

•
Remove the external packaging (wooden box and / or carton) and dispose them in
accordance with the applicable provisions of the installation country.
•
Before first use, remove the protective foil from the device. Peel the foil off slowly, so
as not to leave any glue. If some glue remains, remove it using an appropriate
solvent.
•
Remove from the internal accessories, all information materials and plastic bags.
CAUTION!
Never remove the nameplate and warning notes from the device.
- 53 -