Setup; Loose Parts; Assembling The Handle - Toro 58601 Manual De Instrucciones

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Assembling the Handle

Parts needed for this procedure:
4 Knob nut
4 Curved washer
4 Saddle bolt
1 Middle handlebar
1 Upper left handlebar
1 Upper right handlebar
Procedure
1. Park the machine on a level surface.
2. Set the wheels to the lowest position;
the Wheels (page
3. Attach the middle handlebar to the lower
handlebar.
Note:
You can install it in the upper or lower
holes, depending on height preference.
Important:
Do not overtighten the knob
nuts.
Description
Knob nut
Curved washer
Saddle bolt
Middle handlebar
Upper left handlebar
Upper right handlebar
No parts required
Adjusting
12).
Qty.
4
4
4
Assemble the handle.
1
1
1
–
Rotate the drag stake.
1. Middle handle
2. Lower handle
3. Knob nut (2)
4. Attach the upper right and upper left handlebars
to the middle handlebar.
Important:
Do not overtighten the knob
nuts.
5
Use
Figure 3
4. Curved washer (2)
5. Saddle bolt (2)
g334211