Before Each Use - EnviroBoss EB240 El Manual Del Propietario

Recommended
Cordless drill, small knife, small-jaw pliers, coil
cleaning solution, Rotomolded housing cleaning
solution

Before each use

Inspect the electrical cord for damage. Look for
fraying, cuts, etc. Replace the cord if you find any
damage.
Inspect filter. Replace as needed. NOTICE: Replace
used filters only with a new Legend Brands filter. Other
filter types do not provide adequate filtration or airflow.
Monthly
Inspect coils and heat exchange block. Clean when
dust accumulation is visible. In normal use, dust can
DRAINING/WINTERIZING
The unit is equipped with a drain to allow removal of any
water that might remain in the unit after operating the purge
function. Draining the unit is especially important when the
unit might be exposed to freezing conditions during storage
or transport.
After placing a catch basin under the plug, use a
wrench to remove the drain plug located in the lower right
corner of the rear panel.
Tip: With the drain plug removed, gently shake the unit
and then tip the unit back and to the right. This will
allow for more complete removal of any water that has
collected in the rear panel.
Once any water has drained out, replace the plug. Tighten
until snug. Do not overtighten.
07-02184B EB240
accumulate and can restrict airflow, reducing
performance and causing the unit to overheat.
To maintain appearance, wipe interior and exterior
surfaces with a damp cloth. For deep cleaning and a
lasting, protective shine, use a similar automotive interior
treatment.
As Needed
Clean Pump Check Valve and Basin. If the unit
displays the message "ER9 PUMP BLOCKED CHECK
PUMP & HOSE", the pump check valve and pump basin
may need to be cleaned. This requires removal of the
back cover.
Clean coils and heat exchange block. Inspect the
horizontal evaporator (cold) coil with the back cover
removed. If excessive dust and debris is present,
vacuum thoroughly and/or clean with coil cleaner.
∕
3
in.
8
6 Legend Brands