Wiring Diagram; Outdoor Unit Installation - Whirlpool SPIW409A2WF Instrucciones Para El Uso

WIRING DIAGRAM

•9K/12K/18K/24K Models
Indoor unit
Terminal
0(L)
Power connecting cord
1(L)
2(N)
4(SL)
Note:
For 9k, 12k, 18k, 24K models, the power supply are connected from outdoor unit with a circuit breaker, the
power connection cord ground wire are connected to the outdoor unit electric box directly.

OUTDOOR UNIT INSTALLATION

1. Install Drain Port and Drain Hose
The condensate drains from the outdoor unit when
the unit operates in heating mode. In order not to
disturb your neighbours and protect the
environment, install a drain port and a drain hose to
direct the condensate water. Just install the drain
port on the chassis of the outdoor unit, then
connect a drain hose to the port as shown in the
figure on the right .
2. Install and Fix Outdoor Unit
Fix with bolts and nuts tightly on a flat and strong
floor. If installed on the wall or roof, make sure to
fix the supporter well to prevent it from shaking due
to serious vibration or strong wind.
Recommend: it's better to insert rubber pad
(optional part) under the ODU foot in order to absorb the vibration during running.
3. Outdoor Unit Piping Connection
• Remove the valve caps from the 2-way and 3-way valve.
• Connect the pipes to the 2-way and 3-way valves separately according to the required torque.
4. Outdoor Unit Cable Connection (see previous page)
All manuals and user guides at all-guides.com
Outdoor unit
Terminal
0(L)
Gray
1(L)
2(N)
4(SL)
BN
L
BU
N
YE/GN
Power supply
59
Chassis
Drain port
Drain hose
(prepare by user)