BelFox Drive Portal Instrucciones De Montaje página 76

are already pre-assembled ready to plug in. No clamping work is required for
this. Only the 2-wire supply line of the light barrier transmitter at the inlet post
has to be connected to the 24 V AC power supply (terminals 17 + 18).
All input devices installed in the column:
- both key switches (pulse) - on both sides
- Emergency stop button - inside
are already pre-wired.
Of course, you can connect additional devices to the control system according to
your wishes. (However, only use BELFOX products. With third-party products,
errors can occur and destroy the motor control unit. If third-party products are
used, the warranty will become void). An extra terminal box at a comfortable
working height is provided for this purpose. The individual functions of the
connections can be found in the enclosed control instructions 47-21-0 (optional
control instructions 47-21-i).
Terminal diagram with control
47-21-0
1 Net L
2 Net N
3 Net PE
4 warning light 230 V AC
5 warning light 230 V AC
6 3-minute light 230 V
7 3-minute light 230 V
8 Switch impulse
9 Switch common
10 Switch partial opening
11 Switch partial opening
12 Switch partial opening
13 Stop
14 Stop
15 Main closing edge
16 Main closing edge
17 secondary closing edge
18 secondary closing edge
19 24 V AC max. 0,5 A
20 24 V AC max. 0,5 A
Terminal diagram with control
47-21-i
1 Netz L
2 Netz N
3 Trafo N – 230 V
4 Trafo L – 230 V
5 3-Minutenlicht N - 230 V
6 3-Minutenlic ht L - 230 V
7 Warnlicht N – 230 V
8 Warnlicht L – 230 V
9 Trafo 24 V
10 Trafo 24 V
11 24 V Abgriff – Klemme 10
12 24 V Abgriff – Klemme 9
13 24 V DC - Masse
14 24 V DC - +24 Volt
21 Taster A - Impuls
22 Gemeinsamer A & B
23 Taster B - Auf
24 Taster C – Zu
25 Gemeinsamer C & D
26 Taster D – Teilöffnung
27 Stopp
28 Stopp
29 Lichtschranke
30 Lichtschranke
31 /
32 SE1 (8,2 k )
33 SE2 (8,2 k )
34 /
35 SE1 (8,2 k )
36 SE2 (8,2 k )
28
Ω
Ω
Ω
Ω