Cosatto RAC Guru Manual Del Usuario página 9

Belted only:
Fitting
Softgoods
Tuck in tool
16-
Fasten the vehicle seat belt and close the buckle (a), ensuring
that the diagonal vehicle seat belt is threaded through the
diagonal vehicle seat belt guide and secured (b) then is
threaded above the lap vehicle seat belt guide (c).
The lap vehicle seat belt should be threaded through lap
vehicle seat belt guides (d) under the armrests.
Check the vehicle seat belt has not become twisted and
tighten the seat belt by pulling the diagonal vehicle seat belt
upwards (e).
IMPORTANT: The position of the vehicle seat belt buckle
can affect the stability of the child car seat. In an accident
this could stop the child car seat from protecting your child
as well as it should. After tightening the vehicle seat belt, if
the buckle lies in the position marked
child car seat in another seating position in your vehicle. If
in doubt consult either the child car seat manufacturer or
retailer.
To release, unfasten the vehicle seat belt in the normal way.
Removing:
17-
Raise the headrest to its highest position (Refer to step 1).
Lift fabric cover away from the backrest (a).
Release the popper flap from the rear of the fabric cover (b)
Remove the insert from the fabric cover before washing (c).
18-
Release the fabric cover from the lap belt guides (a) and the
cup holder mounting points (b).
19-
Lift the fabric cover over the headrest (a) and away from the
seat unit.
Refitting is a reversal of this procedure.
20- Using the tuck in tool:
then try fitting the
6