Nolan N71 Seguridad E Instrucciones página 17

- Please refer to the proper section in the helmet user's manual for the VPS and visor
maintenance and cleaning operations.
- The VPS antifog/antiscratch treatment remarkably reduces fogging. Protracted peri-
ods of adverse weather and/or environmental conditions might cause fogging
and/or formation of condensation on the VPS, which entails a reduction of visibility
and/or sharpness of vision: In this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the antifog/antiscratch-treated
VPS quickly reduces sharpness of vision, thus causing scarce visibility: In this case,
deactivate the VPS.
- The special VPS antifog treatment is usually sensitive to high temperatures or heat
sources. In this case, contaminations caused by contact with other materials might
occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case on hot days), it is rec-
ommended to make sure the visor is not touching other materials.
3.2 VPS DISASSEMBLY INSTRUCTIONS
3.2.1 To remove the VPS system from the helmet, open the visor and lower the VPS by
rotating the side slider towards the bottom of the helmet (Fig. 6 B).
3.2.2 Hold the left lateral part of the VPS and lift the VPS to the outside of the helmet (Fig. 7).
3.2.3 Repeat the same operation on the right side of the helmet (Fig. 8).
3.3 VPS ASSEMBLY INSTRUCTIONS
3.3.1 To fit the VPS system from the helmet, open the visor and make sure the side slid-
er is placed towards the bottom of the helmet (Fig. 6 B).
3.3.2 Insert the VPS right end into the right side guide until the grip pawl is hooked in shell
seat (Fig. 8). Repeat the same steps on the left side (Fig. 7).
3.3.3 Check the correct VPS operation by rotating the left side slider upwards (Fig. 6A)
and towards the bottom of the helmet (Fig. 6 B) until you hear the clicks meaning
that it is in the relevant positions. If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunction-
ing, please contact a Nolan authorised dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING
- Since the VPS does not assure you the same protection as the one provided by the
visor, it has to be used only when the helmet visor is pulled down.
4) WIND PROTECTOR
4.1 This accessory allows improved helmet performance under certain conditions of
use. The Wind Protector prevents unpleasant infiltrations of air under the chin.
4.2 See Fig. 9 A - 9 E for the assembly and disassembly:
Insert the lateral fastenings A in the corresponding seats B on the inner chin guard.
4.3 Let the wind protector slide forward by hooking the fastenings C in the correspon-
ding seat D on the inner chin guard.
17