Use Procedure; Error Messages - Varian Turbo-V 300HT Manual De Instrucciones

USE PROCEDURE

Controller Startup
To startup the controller plug the power cable into a
suitable power source and set the line switch to the
position 1.
Starting the pump
To start the pump press the START push-button on the
controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button on
the controller front panel.
MAINTENANCE
The Turbo-V 300HT series controller does not require
any maintenance. Any work performed on the controller
must be carried out by authorized personnel.
All manuals and user guides at all-guides.com
1. Logic input signals connectors
2. Logic output signals connector and pump current monitor.
3. Power output connector (120 Vac,1 A for pump
4. Pump cord.
5. Controller power entry module consisting of mains fuses,
6. Power output connector (120 Vac) for vent device,
7.
Controller 969-9424 and 969-9524 rear panel
47
INSTRUCTIONS FOR USE
supplied with link).
cooling fan).
voltage change over, mains socket and EMC filter.
forepump contactor coils etc.
Provision for RS232 communication port connector
(provide as an option).
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
!
WARNING!
Before carrying out any work on the controller,
disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off in
accordance with the specific national standards.

ERROR MESSAGES

For a certain type of failure, the controller will self-
diagnose the error and the messages described in the
following table are displayed.
(mating connector
87-900-876-01 (B)