Lamp Replacement; After-Sales Service; Thermal Safety Cut-Out - Dimplex SP120 Manual De Instrucciones

Lamp Replacement

WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE REMOVING LAMPS.
Warning - The lamps reach high temperatures during operation. For
this reason, allow the lamps to cool down after switching off the
appliance.
The front panel will need to be removed in order to change lamps – see
Fig. 9.
Warning - The front panel is heavy and easily damaged.
The front panel is fixed with two screws on top and is supported
underneath by the chassis see Fig. 9.
Care is needed to avoid the front panel falling forward while removing
the screws see Fig. 9a.
While holding the front by its sides with both hands carefully tilt forwards
and then lift up and out - see Fig. 9b.
Place the front panel flat on a protective surface such as a matt with
the glass facing away from the floor.
To gain access to lamps please apply the following procedure:
Remove two screws securing fuel effect. Holding the logs carefully lift
up (1) and out (2) for SP1,2 & 3 models - see Fig. 10.
Carefully slide the flexible rotisserie (see Fig. 11a) to one side ensuring
that the rubber grommet is not lost – see Fig. 11b.
Remove the defective lamp by unscrewing it (see Fig. 12).
Replace with a 60W E14 SES Clear Candle bulb, rotating it. Take care
not to over-tighten the lamp.
Steps for reassembling the heater
1. Refit the rotisserie making sure that the rubber grommet is carefully
pushed into the slotted hole on the axial bracket (see Fig. 11c).
2. Refit the fuel effect ensuring that the fuel effect bracket (see Fig.
10b) on the fuel effect slots in between the fuel effect retaining
bracket and the inner glass (see Fig. 10a).
3. Refit the front panel (ensuring that its base is held in place i.e. that
it slots into the channel on the frame (see Fig. 10c) reversing the
steps as outlined previously.

Thermal Safety Cut-out

For your safety, this appliance has been fitted with thermal cut-out. In
the event that the product overheats, the cut-out switches the heat off
automatically.
To bring the heat back into operation, remove the cause of the
overheating, then unplug or turn off the electrical supply to the heater
for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch on the
heater.
Caution: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your
country.
All manuals and user guides at all-guides.com
- 2 -
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with
a soft cloth. DO NOT use proprietary glass cleaners.
After Sales Service
Should you require after sales service or should you need to purchase
any spares, please contact the retailer from whom the appliance was
purchased or contact the service number relevant to your country on
the warranty card.
Please do not return a faulty product to us in the first instance as this
may result in loss or damage and delay in providing you with a
satisfactory service.
Please retain your receipt as proof of purchase.
UK