Elcometer 215 Manual Del Usuario página 15

APPENDIX A: USING ELCOMASTER (continued)
A.2 CREATING A SETTINGS FILE
1 Click on the 'Oven Profiling' tab.
2 Click 'New''Oven Logger'. A
new file is created labelled 'New
Logger Setup x'. To rename file,
right-click and select 'Rename'.
Various tabs are now available which
allow different settings to be configured.
Description: make general notes about the logger.

Channel Set-up: label each channel for example, 'Air Probe Top',

'Surface Probe Bottom'.
Sample Rate Setup: configure

how often readings should be
taken and how many different
batches of readings can be held
on the logger at any one time. For
example, if '4 Batch Runs' is
selected, the logger will hold 4
batches and when the fifth is
created, batch 1 will be deleted.
Note: The maximum run time for each
batch, calculated using the selected
reading rate and number of batches, is
displayed in the yellow box.
Start/Stop Triggers: configure when

to start and stop logging. For start
triggers, the options are to start
logging after holding the 'Set' key;
Manual: start immediately.
Manual with Delay: start logging after
a pre-defined set interval.
Threshold Temperature: start logging
when the temperature of the probe
connected to channel 1 rises above
the set temperature.
Temperature Differential: start
logging after the rate of temperature
increase of the probe connected to
channel 1 rises above the set value.
www.elcometer.com
All manuals and user guides at all-guides.com
®
R
en-14