Preventive Maintenance; Maintenance And Cleaning - Schulz FPB 12VP Serie Manual De Instrucciones

Driving operation mode
Always use the proper bit tip type and size.
Always handle the tool and the bit tip in a straight line with the screw.
5
FIGURE 7.4
13 3
FIGURE 7.5
ATTENTION
pment firmly with the two hands to control twist action and avoid damage to equipment and injury.

8. PREVENTIVE MAINTENANCE

Maintenance and cleaning:

Before performing any cleaning or maintenance, unplug the tool from the power grid;
After use, clean the tool with a damp cloth (do not pour water on the tool) and store it in a clean, dry place
protected from moisture and dust. Keep your tool out of reach of children and people unfamiliar with the use of
the equipment.
Transportation:
Do not pull or carry the tool by the electric cord or allow its contact with edges, sharp elements, rough surfaces,
oil or chemicals that may damage its flexible and insulating properties;
Do not move the tool with the trigger locked in the "on" position;
Repairs:
If required to perform any repair or replacement of the electric motor brushes, contact the nearest Schulz assis-
tance. Original parts Schulz must be used. The use of non-original parts results in warranty loss and may cause
damage to the equipment or injury.
Operation torque adjustment
The tightening torque may be set turning the torque selector to the position desi-
red for the job. The torque is directly proportional to the number of the selected
position. The higher the number, the higher the operating torque.
12
Never overload your electric tool. It may lock and cause a sudden twist. Hold the equi-
Mounting and reming drills and bit tips
- Set the rotation direction button to the central position, preven-
ting inadvertent start of the tool;
- Loosen the chuck by turning it counterclockwise while holding
the back part (12);
- Insert the desired drill (13) into the chuck and tighten it firmly by
turning the chuck clockwise.
28