Cleaning And Maintenance - Dometic AIR Break Pro 1 Door Manual Del Usuario

Keep the following tips in mind while setting up the
windbreak:
• The illustrations provide a general overview of
the set up. The actual set up will vary slightly
based on the model of windbreak.
• Get help. The set up is easier with more people.
• Peg the guy lines so that the windbreak is under
tension without distorting the shape.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
Set up the windbreak as follows:
1. To protect the windbreak from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the windbreak.
3. Separate and identify the different compo-
nents.
4. Proceed as follows depending on the type of
set up:
➤ To connect the windbreak to an awning
tent, set up the windbreak as shown
(fig. 2, page 3 to fig. 6, page 5).
➤ To use the windbreak freestanding (AIR
Break Pro 1/3/5 and AIR Break All-Season
1/3/5 only), set up the windbreak as
shown (fig. 3, page 4 to fig. 6, page 5).
Extending the windbreak
➤To connect the windbreaks use the zippers on
the sides (fig. 8, page 5).
➤To set up the AIR Break Pro Door/ AIR Break
All-Season Door proceed as shown (fig. 9,
page 6 to fig. c, page 7).
Dismantling the windbreak
1. Remove all dirt from the windbreak.
2. Unpeg all pegging points and unclip all guy
lines.
3. Deflate the windbreak:
➤ AIR Break Pro 3/5 and AIR Break All-Sea-
son 3/5: Open the deflation valves
(fig. 7, page 5).
10
➤ AIR Break Pro 1/ Door and AIR Break
All-Season 1/ Door: Open the inflation
valves.
4. Fold/roll the windbreak towards the valves to
expel more air.
5. When deflated, roll the windbreak to fit into
the carry bag.
6. Zip and tighten the compression straps.
7. Ensure that all parts are clean before packing
them into the carry bag.
8. If the windbreak is wet or damp, dry fully as
soon as possible.
Storing the windbreak
I
NOTE
• Fully set up the windbreak for clean-
• Choose a sunny day for cleaning to
1. Clean the windbreak.
2. Air fully and ensure the windbreak is totally dry
before packing away.
3. Store in a well ventilated dry place.

Cleaning and maintenance

A
NOTICE! Damage hazard
• Do not use sharp or hard objects or
• Do not use alcohol based materials,
• Remove bird droppings and tree
1. If necessary, clean the product with clean
water and a soft brush.
2. Apply impregnation against water and UV
radiation before each trip.
4445103328
ing.
ensure the material will dry thoroughly.
cleaning agents for cleaning.
chemicals, soap and detergents for
cleaning.
resin as soon as possible to avoid per-
manent damage to the material.