Prior To Operation - Hazet WERK 9065/6 Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

All manuals and user guides at all-guides.com

Pneumatic tools have to be used,

inspected and maintained always

in compliance with the respective

local, state, national or federal

regulations.

• Drain compressor tank and remove conden-

sation water from the air hoses. Read thou-

roughly through the operating instructions of

the compressor tank too.

Important: The use of air filters and an air hose

oiler is recommended.

Attention! Before oiling, plugging in/out the

tool, disconnect the tool from the com-

pressed air supply.

• For oiling the tool, see "Maintenance and

Cleaning" in these operating instructions.

Attention! Only use chisels and accessories

that are approved for impact operation.

• The right size of the air hose to be connec-

ted to the tool has to correspond to the indi-

cations given in the table on page 8.

Note: The use of a quick-release coupling

facilitates the connection.

• Turn on the compressor to start the filling of

the air tank.

• Adjust the air compressor regulator to 91

PSI (6.3 bar). The maximum working pres-

sure of this tool is 91 PSI (6.3 bar).

• Adjust the regulator of the air inlet to the

desired value in order to avoid too strong

impacts.

• How to insert the chisel:

Take off swivel nut, insert suitable chisel, put

on swivel nut and tighten it.

• Never use damaged chisels.

• Do not use damaged, worn-out or low-qua-

lity air hoses or connectors.

• Press operation trigger to operate the tool.

• Release trigger to stop tool operation.

• Before oiling, plugging in/out the tool,

please make sure that the air supply is dis-

connected.

• When the work is done, switch off compres-

Do not leave plugged-in pneumatic tools unattended.

Always wear personal protective clothing and safety equipment.