Troubleshooting - Craftsman BOLTON 16496 Manual Del Operador

MAINteNANCe
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
iMpOrtant: To assure product saFeTy and ReLiaBiLiTy, repairs, maintenance, and adjustment
(other than those listed in this manual) should be performed by
qualified service personnel
ACCeSSORIeS
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous.
Additional attachments and accessories for use with this tool are available at extra cost from your local
Sears store or Sears service center.
If you need assistance regarding accessories, please call:
This Class B digital apparatus complies with Canadian iCes-003.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOte: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This Class B digital apparatus complies with
Canadian iCes-003.
Problem
• Unit will not start.
• Battery pack will not
charge.
• Unit shuts off
abruptly.
All manuals and user guides at all-guides.com
.

tROUBleShOOtING

Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• attachment is not secured.
• Battery pack not inserted into charger.
• Charger not plugged in.
• surrounding air temperature too hot
or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( to maximize battery
life, the battery pack is designed to
shutoff abruptly when the charge
is depleted.)
a qualified service dealer or other
1-877-795-2353
Possible Solution
• Check battery pack installation.
• Check battery pack charging
requirements.
• make certain the attachment is fully
pushed into the Power Unit.
• insert battery pack into charger until
LED illuminates.
• plug charger into a working outlet.
Refer to "important Charging Notes"
for more details.
• move charger and battery pack to
a surrounding air temperature of
above 40 degrees F (4,5°C) or below
105 degrees F (40,5°C).
• allow battery pack to cool down.
• place on charger and allow to charge.
12
.