General Operation; Checks Before Each Start-Up - Snapper 1226 Manual Del Operador

Ocultar thumbs Ver también para 1226:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GENERAL OPERATION

CHECKS BEFORE EACH START-UP

1. Make sure all safety guards are in place and all nuts,
bolts and clips are secure.
2. Check to make sure that the clean-out tool is
attached to the auger housing. Do not operate the
machine without the clean-out tool properly stored on
the auger housing.
3. Check the engine oil level. See your engine owner's
manual for procedure and specifications.
4. Check to make sure spark plug wire is attached and
spark plug is tightened securely. If necessary, torque
spark plug to 15 ft. lbs.
5. Check the fuel supply. Leave a minimun of one inch
of space at top of tank for fuel expansion. See your
engine owner's manual for fuel recommendations.
6. Check the scraper bar to make sure it is set at the
desired height. Adjust the skid shoes if necessary.
7. Check the drive control (B, Figure 21), and auger
control (C) for proper operation. If adjustment is
required, see the service section for procedures.
8. Check the chute direction control (D, Figure 21) for
proper operation. The discharge chute should rotate
freely in both directions. See the service section for
adjustment procedures and troubleshooting.
9. Check the chute deflector (E, Figure 21) for proper
operation. The deflector should pivot freely up and
down.
10. Position the chute at the desired starting direction
and set the deflector at the desired angle.
11. Check the speed selector (A, Figure 21) for smooth
operation. The control must move freely into each
speed position gate and remain in position when
released. If the speed selector does not move freely
into all forward and reverse speed positions, contact
your local authorized dealer for assistance.
All manuals and user guides at all-guides.com
This unit is a "two-stage" snowthrower.
The first stage is the auger, which feeds the snow
back into the impeller housing. The second stage
is the impeller, which throws the snow out the
discharge chute. If bodily contact is made with
the auger or impeller when they are rotating,
severe personal injury will occur.
To avoid injury, keep others and yourself away
from the auger and the discharge chute whenever
the engine is running. Read and follow all of the
safety rules and warnings in this manual.
Do not clean out discharge chute with hands.
Contact with moving parts inside chute will
cause serious injury. Use clean out tool provided
with machine. Use the following procedure to
remove objects or clear the chute:
1. Stop the engine. Remove the key.
2. Wait 10 seconds to be sure the auger/impeller
3. Always use the clean-out tool. DO NOT use your
For your safety, operation on slopes should be
in an up and down direction only. If it becomes
necessary to move across the face of a slope, use
caution and do not blow snow. Be very careful
when changing direction on a slope.
Proper winter footwear is recommended for the
operator to help prevent slipping. Never attempt
to clean snow from excessively steep slopes. The
maximum slope for any operation is 17.7% (10º).
Gasoline is highly flammable and must be han-
dled with care. Never fill the tank when the engine
is hot or running. Always move outdoors to fill
the tank. Keep snowthrower and gasoline away
from open flame or spark.
17
WARNING
DANGER
blades have stopped rotating.
hands.
WARNING
WARNING
Operation

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1695571

Tabla de contenido