Maintenance And Cleaning; Noise/Vibration Information; Declaration Of Conformity - Würth master HKS 28-A Instrucciones Para El Empleo

All manuals and user guides at all-guides.com
HKS 28 A - Buch Seite 18 Montag, 10. Dezember 2007 3:20 15
The correct selection of the saw blade depends on
the type and quality of the wood and whether
lengthway or crossway cuts are required.
Beech and oak dust is especially detrimental to
health. Therefore, work only with dust extraction.

Maintenance and Cleaning

Before any work on the machine itself, remove
the battery.
Always keep the machine and the ventilation slots
clean.
The blade guard must always be able to move freely
and retract automatically. Therefore, always keep
the area around the blade guard clean. Remove
sawdust and chips with a brush or by blowing out
with compressed air.
Uncoated saw blades can be protected from corro-
sion with a thin coat of acid-free oil. Remove the oil
again before use to prevent spotting of wood.
Resin and glue residue on the saw blade cause poor
cutting results. Therefore, clean the saw blade imme-
diately after use.
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
For all correspondence and spare parts orders, al-
ways include the article number on the type plate of
the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power tools that are
no longer suitable for use must be separately collect-
ed and sent for recovery in an environmental-friend-
ly manner.
18
Battery packs/batteries:
Do not dispose of battery packs/batteries into
household waste, water or fire. Battery packs/bat-
teries must be collected, recycled or disposed of in
an environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled accord-
ing to the directive 91/157/EEC.
For this Würth tool, we provide a warranty in ac-
cordance with statutory/country-specific regulations
from the date of purchase (proof of purchase by in-
voice or delivery note). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.

Noise/Vibration Information

Measured
EN 60 745.
Typically the A-weighted noise levels of the machine
are:
Sound pressure level: 98 dB (A);
Sound power level: 109 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 55 014-1, EN 55 014-2, EN 60 745 according
to the provisions of the regulations 98/37/EC,
2004/108/EC.
07
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Warranty
values determined according
R. Bauer
to
2
.