Publicidad
Idiomas disponibles
Idiomas disponibles
STP 28-A.book Seite 17 Mittwoch, 6. März 2019 8:50 08
Sawdust Blower Device
The sawdust blower device leads an air jet to the
saw blade. The air jet keeps sawdust from covering
the cutting line during operation.
The air jet can be adjusted with the switch for the
sawdust blower device 15.
Pendulum Action Setting
The pendulum action can be adjusted
in four steps with the adjustment le-
ver 9. Switching is possible with the
machine running:
No pendulum action
Step 0:
Step I:
Small pendulum action
Step II:
Medium pendulum action
Step III:
Large pendulum action
Recommendations:
– The more narrow and clean the cutting edge
should be, the lower the pendulum action level
should be selected (or switched off).
– For thin materials, e. g. sheet metal, switch the
pendulum action off.
– For hard materials, e. g. steel, work with low pen-
dulum action.
– For soft materials and when sawing in the direction
of the grain, work with maximum pendulum action.
The optimal setting can be determined by practical
testing.
Dust Protection
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are con-
sidered as carcinogenic, especially in connection
with wood-treatment additives (chromate, wood
preservative). Materials containing asbestos may
only be worked by specialists.
- Use dust extraction whenever possible.
- Provide for good ventilation of the working
place.
- It is recommended to wear a P2 filter-class res-
pirator.
Observe the relevant regulations in your country
for the materials to be worked.
Maintenance and Cleaning
Before any work on the machine itself, remove
the battery.
For safe and proper working, always keep the
machine and the ventilation slots clean.
In order to avoid operational malfunctions, do not
saw gypsum board from below or overhead.
The guide roller 11 should occasionally be checked
for wear and lubricated with a drop of oil. If it is
worn, it must be replaced.
If the machine should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorized customer service agent
for Würth power tools.
For all correspondence and spare parts orders, al-
ways include the article number on the type plate of
the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
Disposal
Electrical devices/tools as well as
batteries/rechargeable
may not be disposed of together with
household waste. Electrical equip-
ment and batteries must be collected
separately and disposed of environ-
mental-friendly at a recycling facility. Check with the
local authorities or your specialist shop for recycling
facilities and collection points.
Transporting Lithium
Batteries
Lithium-ion batteries are subject to the Dangerous
Goods Legislation requirements.
Transportation of those batteries has to be done in
accordance with local, national and international
provisions and regulations.
The user can transport the batteries by road without
further requirements.
Commercial transport of Lithium-Ion batteries by
third parties is subject to Dangerous Goods regula-
tions. Transport preparation and transport are
exclusively to be carried out by appropriately
trained persons and the process has to be accompa-
nied by corresponding experts.
batteries
17
Publicidad
