Electrical Safety - Black and Decker V1250 H1 Manual Del Usuario

In case of skin or eye contact, follow
u
the instructions below.
Warning! The battery fluid may cause
personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger only
u
to charge the battery in the appliance/
tool with which it was supplied. Other
batteries could burst, causing personal
injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a
specific mains voltage. Always check that
the mains voltage corresponds to the
#
voltage on the rating plate.
Your charger is double
insulated.
Features
1. On/off switch
2. Release button
3. Dust bowl
Fig. A
4. Charging base
5. Charger
ENGLISH
Installation
Fitting the charging base to the wall
The charging base can be fitted to the
wall to provide a convenient storage and
charging point for the appliance.
Before first use
Before first use, the battery must be
charged for at least 16 hours.
Use
Charging the battery (fig. D)
Make sure that the appliance is
u
switched off. The battery will not be
charged with the on/off switch in
the on position.
Place the appliance on the charging
u
base as shown.
Plug in the charger.
u
Switch on at the mains.
u
Leave the appliance to charge for
u
at least 16 hours.
Whilst charging, the charger may
become warm. This is normal and does
not indicate a problem. The appliance
can be left connected to the charger
indefinitely.
Important! Place the appliance on the
charging base whenever it is not in use. Do
not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Operating the appliance (fig. E)
To switch on, slide the on/off switch
u
(1) forward.
To switch off, slide the on/off switch
u
back.
Accessories (fig. B & C)
V1250/V4810/V4820/V7210/V9650
These models are supplied with the
following accessories:
a hard brush (6) for furniture and
u
stairs (not for V4820)
a crevice tool (7) for confined spaces
u
a soft brush (8) for keyboards and
u
lamp shades (V4820)
5