Set Up Virtual Wall / Boundary Strip; Cleaning And Maintenance - EUFY RoboVac X8 Hybrid Manual Del Usuario

English

Set Up Virtual Wall / Boundary Strip

Virtual Wall (Available on the App Only)
In the EufyHome app, you can set up a "No-Go Zone" or "Virtual Wall" as a restricted area.
This eliminates the need to use physical barriers, including Boundary Strips. This feature is
only designed for dividing the cleaning zones, not for isolating hazardous areas.
• No-Go Zone: RoboVac will not enter the zone to vacuum.
• Virtual Wall: RoboVac will not cross the virtual wall.
• To set a virtual wall, RoboVac must initially perform a cleaning run to
create a floor plan.
• Although a virtual wall is set, RoboVac may still enter the restricted zone
due to repositioning failure or abnormal sensors.
• Moving the device or changing the environment may lose the virtual wall
and cause mapping to fail and rebuild.
Boundary Strips
Boundary strips (sold separately) can keep RoboVac away from hazardous areas.
RoboVac will recognize the barriers and will not cross into the blocked-off area.
1. Identify the area or item you do not want RoboVac to get close to.
2. Place the boundary strips FLAT on the floor or under a rug.
• Do not place the boundary strips under a THICK rug as RoboVac may fail to
recognize the boundary strip.
• Make sure the boundary strips are placed on the same surface plane
RoboVac is used on.
• If the boundary strips roll up, remove and then re-apply to the floor with
adhesive tape. Otherwise the boundary strips may not work well.
34

Cleaning and Maintenance

Before cleaning and maintaining, turn off the device and unplug the adapter.
For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning / replacement frequency will depend on your RoboVac usage
habits.
Recommended Cleaning / Replacement Frequency
RoboVac Part Cleaning Frequency
Dust Collector After each use
Filter Once every week
Rolling Brush Once every week
Side Brush Once every month
Brush Guard Once every month
Sensors Once every month
Charging Pins Once every month
Swivel Wheel Once every month
Water Tank After each use
Washable After each use
Mopping Cloth
Water Tank -
Filters
English
Replacement Frequency
-
Every 3 months
Every 6-12 months
Every 3-6 months (or when
visibly worn)
Every 3-6 months (or when
the silicone rubber strip on the
brush guard becomes visibly
worn)
-
-
-
-
-
Every 6 months (or when they
become yellow)
35