技术数据 - SICK WTT190LC Manual De Operación

54 技术数据
54.1 技术数据
8024108 | SICK
Subject to change without notice
LED 指示灯 / 故障界面 /
LED indicator/fault pattern
Green LED lights up, no
output signal when object is
detected
绿色 LED 闪烁 /
Green LED flashes
不符合图 F 的开关量输出 /
Switching outputs not
according to graphic F
不符合图 F 的开关量输出 /
Switching outputs not
according to graphic F
黄色 LED 同步闪烁。 /
Yellow LEDs flash at the
same time
黄色 LED 闪烁（非常短
暂） /
Yellow LED flashes (only
briefly)
黄色 LED 亮起，光路中无物
体 /
Yellow LED lights up, no
object in the path of the
beam
光路中有物体，黄色 LED 未
亮起 /
Object is in the path of the
beam, yellow LED does not
light up
激光等级
开关距离
最大开关距离
光斑直径/距离
供电电压 U
B
输出电流 I
max.
原因 /
Cause
Test input (Test) is not
connected properly
IO-Link 通信 /
IO-Link communication
IO-Link 通信 /
IO-Link communication
手动执行，可标准有所偏差
的参数设置 /
Parameter settings made
manually, which deviate
from the standard
传感器未准备就绪。环境温
度低时传感器处于预热阶
段。环境温度高时传感器自
行关闭。 /
The sensor is not ready for
operation. The sensor will
be in the warming-up phase
at low ambient
temperatures. The sensor
will have shut down at
excessively high ambient
temperatures.
示教模式 /
Teach-in mode
传感器和背景之间的间距过
小 /
Distance between the
sensor and the background
is too short
传感器和物体之间的间距过
大或开关距离设置的过小 /
Distance between the
sensor and the object is too
long or sensing range is set
too short
WTT190LC-B2233
1
0.2 ... 3.0 m
0.2 ... 3.0 m
< 12.0 mm / 3,0 m
DC 12 ... 30 V
≤ 100 mA
54
技术数据
措施 /
Measures
See the note on connecting
the TI
-
-
启用恢复出厂设置。将开关
输出端重新设置为出厂设
置。 /
Initiate a factory reset. The
switching outputs are reset
to factory settings.
环境温度低时请等待，至传
感器完成预热。环境温度高
时请降温。 /
At low ambient
temperatures, wait until the
sensor has warmed up.
Ensure the sensor cools
down at excessively high
ambient temperatures.
检查示教模式 /
Check the teach-in mode
降低开关距离，参见图 F /
Reduce the sensing range,
see graphic F
增大开关距离，参见图 F /
Increase the sensing range,
see graphic F
1)
1)
95