Brink 705161 Instrucciones De Montaje página 6

Connect the contact insert in the socket as follows:
Cable
yellow
blue
white
green
brown
red
black
blue/white
Replace the contact insert into the socket casing and lock into place and push the rubber seal onto
the socket and attach the socket to the support plate with the enclosed nuts and bolts.
CAUTION!
a) When installing the socket ensure that the connecting cables are not pinched and cannot be
damaged and/or block the mechanical lifting of the contact plate!
b) Ensure that seals are fitted properly! The seal at the cable outlet from the socket must fit on the
insulating tube, not only on the individual wires!
c) Lay the cable set so that no chafing can occur!
d) Do not lay the cable set near the exhaust system! (If required, fix the set of wires on the left side
in the area of the exhaust unit using the enclosed foam pads.)
Insert the wire set marked
Disconnect vehicle-fitted 6-way plug housing from right rear light, connect and lock with mating
connector of cable set.
Connect and lock remaining 6-way plug housing of cable set onto right rear light.
Fix the wire set in the hollow space using the enclosed foam pads.
L
Das mit gekennzeichnete Leitungssatzende durch den Hohlraum nach innen zur linken
Schlußleuchte verlegen.
Disconnect vehicle-fitted 6-way plug housing from left rear light, connect and lock with mating
connector of cable set.
Connect and lock remaining 6-way plug housing of cable set onto left rear light.
Fix the wire set in the hollow space using the enclosed foam pads.
Connect cable lug of the white cable to existing ground point under to left rear light.
050307-190716
Contact no. Function
1/L Indicator, left
2/54g Rear fog light for trailer
3/31 Earth
4/R Indicator, right
5/58R Rear light, right
6/54 Brake lights
7/58L Rear light, left
8/58b Rear fog light for towing vehicle
R
through the hollow area and push it inwards towards the right tail lamp.
6 / 24