TOOLS
1 Exhaust Camshaft Locking Tool,
to be used as OEM KM6204 (MOT1537)
2 Inlet Camshaft Locking Tool,
to be used as OEM KM6205 (MOT1534)
3 Tensioner Tool Set (5 parts), to be used as
OEM MOT1543
4 Screw M6 x 30 mm
5 Pump Locking Pin, to be used as OEM MOT1538
6 Crankshaft Timing Pin, to be used as
OEM KM6203 (MOT1536)
7 Crankshaft Timing Pin, to be used as
OEM MOT1489
8 Timing Pin, to be used as
OEM MOT1430
INTENDED USE
This tool set is used to set and check the engine timing in e.g. Timing belt / timing chain replacement
and renewal of the cylinder head gasket.
Further information on the article and a list of suitable motors and models can be found on our
website:
www.bgstechnic.com
SAFETY ADVICE
•
DO NOT use the set if any parts are missing or damaged.
•
Never lay tools on the vehicle's battery. This may short the terminals together.
•
Be careful when working on running engines. Loose clothes, tools and other things can be
caught up in revolving parts which may lead to serious injuries.
•
Keep children and other unauthorised persons away from the working area.
•
Be careful when working on hot engines – risk of burn!
•
Remove the ignition key before repair so that the engine will not start unintentionally.
•
This manual is just brief information and will not replace a garage handbook.
•
Always consult specific service literature for information about torques, assemblies and
disassemblies etc.
•
After any successful maintenance and before starting the engine, you should rotate the
engine for two turns manually to check the new control time.
•
Do not use cleaning fluids on belts, sprockets or rollers
•
Turn the engine in the normal direction (clockwise unless stated otherwise)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Engine Timing Tool Set
Renault, Nissan & Vauxhall
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 62505
5
4
2
1
3
3
3
3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
6
7
8
3