Mettler Toledo IND310drive Manual De Instalación página 33

Jumpers/
On Off
LEDs
W2
W4 X
W5
CS4 X
CS3 X
CS2 X
CS1 X
LED1 X
LED1 X
LED1 X X
Table 2-10: Single Analog Load Cell—Scale 2
Jumpers/
On Off
LEDs
W1
IRQ1 X
IRQ2 X
IRQ7 X
X
W2
X
X
2
W3
X
W4
CS4 X
CS3 X
CS2 X
CS1 X
2
Jumper W3 is only available on dual analog load cell boards.
IND310drive Installation Manual
Description
W2 is a three-pin configuration. If the jumper is in the
12V position, 12 volts is supplied from the IND310drive
terminal. If the jumper is in the 24V position, 24 volts is
supplied from an external power source. The external
power source is connected to J2 on the POWERCELL
load cell board. Pin 1 of J2 is +24V and Pin 2 of J2 is
Ground. The external power source is not supplied with
the IND310drive terminal.
This jumper activates the internal terminating resistor for
RS485.
W5 is a four-position jumper set. Only one jumper
should be connected.
Power on.
Power off. If unit is plugged in, check main power,
power connections, proper seating of the board, and
fuses before contacting service.
Flashing. POWERCELL is connected and communication
is ok.
Description
W1 is a three-position jumper set. Only one jumper
should be connected.
This jumper sets the connected scale's load cell setting
to 2 mV/V.
No jumper sets the connected scale's load cell setting to
3 mV/V
This jumper sets Scale 2 to 2 mV/V.
No jumper on W2 sets Scale 2 to 3 mV/V
W4 is a four-position jumper set. Only one jumper
should be connected.
2-15