Grounding The Generator; Starting The Engine - Briggs & Stratton ELITE Serie Manual Del Propietário

GROUNDING THE
GENERATOR
The National Electrical Code requires that the frame and
external electrically conductive parts of this generator be
properly connected to an approved earth ground. Local
electrical codes may also require additional grounding of
the unit. For that purpose, a GROUNDING FASTENER is
provided on the generator end (Figure 3).
Figure 3 — Grounding Fastener
Grounding
Fastener
Generally, connecting a No. 12 AWG (American Wire
Gauge) stranded copper wire to the grounding fastener and
to an earth–driven copper or brass grounding rod
(electrode) provides adequate protection against electrical
shock. Be careful to keep the grounding wire attached after
connecting the stranded copper wire. However, local codes
may vary widely. Consult with a local electrician for
grounding requirements in your area.
Properly grounding the generator helps prevent electrical
shock if a ground fault condition exists in the generator or
in connected electrical devices, especially when the unit is
equipped with a wheel kit. Proper grounding also helps
dissipate static electricity, which often builds up in
ungrounded devices.
OPERATING THE
GENERATOR
CAUTION!
NEVER start or stop unit with
electrical loads connected AND with the connected
devices turned ON.
IMPORTANT: Always unplug the battery float charger
before starting the generator.
10000W Generator

Starting the Engine

Disconnect all electrical loads from the generator. Follow
start instruction steps in numerical order:
1. Turn the fuel valve to the "On" position (Figure 4).The
fuel valve handle should be vertical (pointing toward
the ground) for fuel to flow.
Figure 4 — Fuel Valve
Fuel Valve is shown
in "On" position
2. Make sure the Idle Control switch is in "Off" position
(Figure 5).
Figure 5 — Idle Control Switch
3. Set the Ignition switch to "On" (–) position (Figure 6).
Figure 6 — Ignition Switch
4. Start the engine according to instructions given in the
engine owner's manual.
8