Sthor 78123 Manual Del Usuario página 12

CHARACTERISTICS OF TOOL
Multifunctional oscillating tool is an ordinary power tool, which does not require an external power source, it is mainly designed
for fi nishing works with processing of wood plastic, and metal, especially in the corners and places, which are diffi cult to access.
The tool allows for cutting, grinding, surface cleaning and polishing by using a suitable insertion tool. In any case, you should
not use the tools for the machining of materials other than those listed above, for example. for grinding plaster, fi llers with fi ber
reinforcement, etc. reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
Attention! The dust generated during grinding of certain surfaces can be harmful for health, and even toxic.
This note applies to i.a. grinding the surfaces coated with paints containing lead, to some species of wood, some metals (e.g.
lead) and materials, therefore, during the work you should use an eff ective dust extraction, dust masks and other measures to
protect the skin and respiratory tract. For any damage caused by failure to comply with safety regulations and instructions of this
manual, the supplier is not responsible.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. except for the installation of the insert tool, which is
described further in this manual. The product is supplied with the battery charger charging station (charger) and the inserted
tool.
Attention! The product of the catalog number: 78124 has not been equipped with a rechargeable battery and charging station.
TECHNICAL PARAMETRES
Parameter
Catalogue number
Operating voltage
Number of oscillations
Noise level
- acoustic pressure
- LWA power
Protection grade
Insulation class
Level of vibration (drilling / screwdriveting)
Mass
Battery
Capacity of the battery*
Charger*
Input voltage
Mains frequency
Rated current
Output voltage
Input current
Time of charging**
* only for models equipped with battery and charger
** charging time applies only to the battery with a capacity listed in table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do
not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours. Do not allow
O R I G I N A L
12
GB
Unit of measurement
[V]
[min -1 ]
[dB]
[dB]
[m/s ]
2
[kg]
[Ah]
[V~]
[Hz]
[A]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
78123, 78124
12 DC
5 000 - 18 000
94,0 ± 3,0
105,0 ± 3,0
IPX0
III
11,240 ± 1,5
0,9
Li-Ion
1,5
100 - 240
50 / 60
1,0
13,5 DC
1,8
1