Technical Data; Before Use - Hilti HDE 500-A22 Manual De Instrucciones

NOTE
Indication of the charge status is not possible while the tool is in operation or immediately after operation. If the battery
charge status LEDs blink, please refer to the information given in the Troubleshooting section.

4 Technical data

Right of technical changes reserved.
en
Power tool
Weight in accordance with EPTA procedure 01/2003
Rated voltage (DC voltage)
Dispensing mode selector switch
Noise information (measured in accordance with EN 60745‑1):
Typical A-weighted sound power level, L
Uncertainty for the given sound level, K
Typical A-weighted emission sound pressure level, L
Uncertainty for the given sound level, K
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase the level of exposure over the total working period. An accurate estimation of exposure should
also take into account the times when the tool is switched off, or when it is running but not actually being used for a
job. This may significantly reduce the level of exposure over the total working period. You should lay down additional
safety measures to protect the operator from the effects of noise and/or vibration, such as: maintaining the tool and
accessories, keeping the hands warm, organization of work patterns.
Total vibration (vector sum of three directions), Dis-
pensing a
h
Uncertainty, K
ah
Battery
Rated voltage
Capacity
Weight
No. of cells

5 Before use

5.1 Inserting the battery 2
CAUTION
Before inserting the battery, check that the dispenser
output regulator switch is in the "off" position.
CAUTION A falling battery may present a risk of
1.
injury to yourself and others.
Check that the battery is securely seated in the tool.
14
All manuals and user guides at all-guides.com
WA
WA
pA
pA
B 22/1.6 Li‑Ion
21.6 V
1.6 Ah
0.48 kg
6
2.62 kg
21.6 V
Modes available: off, continuous dispensing, measured
volume dispensing with settings 1 to 15
78 dB (A)
3 dB (A)
67 dB (A)
3 dB (A)
0.5 m/s²
1.5 m/s²
B 22/2.6 Li‑Ion (01)
21.6 V
2.6 Ah
0.78 kg
12
5.2 Removing the battery 3
5.3 Transport and storage of batteries
Pull the battery out of the locked position (working posi-
tion) and move it into the first latching position (transport
position).
Observe national and international transport regulations
when shipping batteries (transportation by road, rail, sea
or air).
B 22/3.3 Li‑Ion
21.6 V
3.3 Ah
0.78 kg
12