Troubleshooting
This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions:
Fault
Possible cause
The plug is not connected.
The mains socket is not
The display
supplying power.
indicates nothing.
The display is switched off
automatically or manually.
The volume is set to mini-
mum.
No sound.
The device is in clock/
standby mode.
Static noise in the
The reception is weak.
radio reception.
The time and
No batteries in the battery
station presets are
compartment
lost after a power
are dead.
failure.
No automatic time
The RDS signal is too weak.
setting.
NOTE
►
If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see section "Service").
│
GB │ MT
■
84
All manuals and user guides at all-guides.com
or batteries
Remedy
Insert the power plug into the socket.
Check the house mains fuse.
Press any button on the device.
Increase the volume with the
−VOLUME+ | ON/OFF
Press the −VOLUME+ | ON/OFF dial
to switch on the radio mode.
Try to improve reception by moving the
wire aerial
.
| ST/MO
Press and hold the
button
for about 2 seconds to
switch the station to mono.
Check that the batteries have sufficient
voltage and replace them if necessary.
The time and station presets will need
to be reprogrammed.
The time must be set manually.
dial.
SKR 800 B2