General Lubrication; Recommended Lubricants; Load Chain - Ingersoll Rand KM Serie Información Del Producto

Hoists Not in Regular Use
1. Equipment which has been idle for a period of one month or more, but less than six months, shall be given an
inspection conforming to the requirements of "Frequent Inspection" section on page 7 before being placed in
service.
2. Equipment which has been idle for a period of over six months shall be given a complete inspection conforming
with requirements of 'Periodic Inspection' before being placed in service. Refer to Product Maintenance
Information Manual.
3. Standby equipment shall be inspected at least semiannually in accordance with requirements of 'Frequent
Inspection'.
To ensure continued satisfactory operation of the hoist, all points requiring lubrication must be serviced with correct
lubricant at the proper time interval as indicated for each assembly. Lubrication intervals recommended in the
Maintenance manual are based on intermittent service run time and if the hoist is operated more frequently a more
frequent lubrication schedule will be required. Also, lubricant types and change intervals are based on operation in
an environment relatively free of dust, moisture, and corrosive fumes. Use only those lubricants recommended. Other
lubricants may affect performance of hoist. Failure to observe this precaution may result in damage to the hoist and
it's associated components.
Thread lubricant or an antiseize compound use is recommended for threaded shafts, capscrews and nuts. Unless
otherwise stated, remove old lubricant, clean the part with an acid free solvent and apply a new coating of lubricant
to the part before assembly.

General Lubrication

Correct lubrication is one of the most important factors in maintaining efficient product operation

Recommended Lubricants

Gears (31 and 32)
1. Remove nuts (36) and gear cover (35).
2. Remove old grease and replace with new.
Table 5: Recommended Lubricants for Gears (31 and 32)
Temperature
-20° to 50° F (-29° to 10° C)
30° to 120° F (-1° to 49° C)

Load Chain

• Failure to maintain clean and well lubricated load chain may result in chain failure causing injury, death
or substantial property damage.
1. Lubricate each link of the load chain weekly, or more frequently, depending on severity of service. Apply new
lubricant over existing layer.
2. In severe applications or corrosive environments, lubricate more frequently than normal.
3. Lubricate hook and hook latch pivot points with the same lubricant used on the load chain.
4. To remove rust or abrasive dust build-up, clean chain with acid free solvent. After cleaning, lubricate the chain.
5. Use Ingersoll Rand LUBRI-LINK-GREEN® or an ISO VG220 to 320 (SAE 50W to 90 EP) oil
Form 48489223 Edition 2
All manuals and user guides at all-guides.com
LUBRICATION
EP 1 multipurpose lithium based grease
EP 2 multipurpose lithium based grease
WARNING
Grade Type
9