Safety Instructions; Invalid Cal Data/Damage To Modules - COBHAM AXRF RF Subsystem Guia De Inicio Rapido

These requirements apply to both the AXRF RF Subsystem and the AutoCal Unit, unless otherwise
specified.
For user safety, read and follow all instructions,
manual and on the associated instrument before handling or operating the instrument.
Read these safety instructions carefully.
Keep this manual for future reference.
Read the specifications section of this manual for information about the operating environment of
the instrument.
When installing/mounting or uninstalling/removing an instrument:
turn off power and unplug any power cords/cables.
To avoid electrical shock and/or damage to the instrument:
keep the instrument away from water or liquid sources;
keep the instrument away from high heat or high humidity;
keep the instrument properly ventilated (do not block or cover ventilation openings);
make sure to use recommended voltage and power source settings;
always install and operate the instrument near an easily accessible electrical socket-outlet;
secure the power cord (do not place any object on/over the power cord);
only install/attach and operate the instrument on stable surfaces and/or recommended
mountings;
if the instrument is not to be used for long periods, turn it off and unplug it from its power source.
Never attempt to repair an instrument. Instruments should only be serviced by qualified personnel.
An instrument must be serviced by authorized technicians when:
the power cord or plug is damaged;
liquid has penetrated the instrument;
it has been exposed to high humidity/moisture;
it is not functioning or does not function according to the user manual;
it has been dropped and/or damaged;
it has an obvious sign of breakage.

Invalid cal data/damage to modules

Do not remove any of the installed PXI modules. Removing a module invalidates the system
calibration data supplied with the AXRF RF Subsystem, and may damage the module.

Safety instructions

PXI is a trademark of the PXI Systems Alliance
NI and LabVIEW are the registered trademarks of National Instruments Inc.
Product and company names listed are trademarks or trade names of their respective companies.
WARNINGS, CAUTIONS, and Notes
v
marked in this