Installing The Unit - Allied Telesyn AT-EX1001SC/GM1 Guia De Instalacion

Installing the Unit

To install the AT-EX1001SC/GM1 Multimode Extender on a desktop, perform
the following steps:
1. Remove all components from the shipping package and store the
packaging material in a safe location.
2. Locate a level, secure surface for the unit.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. ! 10
3. Apply AC power to the AT-EX1001SC/GM1 Multimode Extender by
plugging the power cord into the AC power connector on the front of the
unit and plugging the other end into a wall outlet. Check that the Power
LED illuminates.
Caution
Do not remove the dust covers from the fiber optic ports on the unit until
you are ready to connect the cables. Dust contamination can adversely
impact the operation of the ports.
4. Remove the dust cover from Port 1 (P1) on the AT-EX1001SC/GM1
Multimode Extender.
5. Connect the appropriate fiber optic cable to Port 1 (P1) on the Gigabit
Ethernet multimode extender. The cable should connect the TX port of one
AT-EX1001SC/GM1 Multimode Extender to the RX port of the other
multimode extender.
6. Remove the dust cover from Port 2 (P2) on the AT-EX1001SC/GM1
Multimode Extender.
7. Connect one end of the fiber optic cable to Port 2 (P2) and the other end to
the host. The cable should connect the TX port of the extender to the RX
port of the host device. Similarly, the RX port of the extender should
connect to the TX port of the host device.
8. Check that the LEDs on the unit. Refer to Table 1 for a description of the
functions of each LED.
AT-EX1001SC/GM1 Installation Guide
9